Trigger Systems specializes in aquarium sump manufacturing and are based here in the USA (Dallas, TX). All Trigger sumps come with a full top support brace which is made of a solid piece of material to prevent bowing over time from the humidity and water pressure. They also round the corners instead of squaring them which exponentially increases the strength of the corners.
Features
100 Micron filter sock - 7” diameter w/ countersunk locking holder
Two 1” drain inputs
Five ¼” quick disconnect fittings with rigid pipe for dosing/top-off
Four port probe holder with securing O-rings
Adjustable water level in skimmer chamber
Configurable chamber for refugium or ATO reservoir
Heater holder
Cable organizer/holder
Distribution/silencing drip plate with foam block pre-filter
Laser engraved water level indicator
Dual Filter media chamber with foam block pre-filter
Adjustable Water Level
Water level in the sump is adjustable from 7” to 9.5”. This feature is to accommodate for the water height requirements for different protein skimmers.
Locking Filter Sock Holder
Filter socks snap and lock into the filter sock holders to secure the filter sock from falling out when it becomes clogged and needs to be cleaned or replaced. The 7” filter socks are 100 micron rating.
Probe Holders
These sumps come with a probe holder that can hold up to four probes. The holes are 0.63” in diameter.
Trigger Systems specializes in aquarium sump manufacturing and are based here in the USA (Dallas, TX). All Trigger sumps come with a full top support brace which is made of a solid piece of material to prevent bowing over time from the humidity and water pressure. They also round the corners instead of squaring them which exponentially increases the strength of the corners.
Features
100 Micron filter sock - 7” diameter w/ countersunk locking holder
Two 1” drain inputs
Five ¼” quick disconnect fittings with rigid pipe for dosing/top-off
Four port probe holder with securing O-rings
Adjustable water level in skimmer chamber
Configurable chamber for refugium or ATO reservoir
Heater holder
Cable organizer/holder
Distribution/silencing drip plate with foam block pre-filter
Laser engraved water level indicator
Dual Filter media chamber with foam block pre-filter
Adjustable Water Level
Water level in the sump is adjustable from 7” to 9.5”. This feature is to accommodate for the water height requirements for different protein skimmers.
Locking Filter Sock Holder
Filter socks snap and lock into the filter sock holders to secure the filter sock from falling out when it becomes clogged and needs to be cleaned or replaced. The 7” filter socks are 100 micron rating.
Probe Holders
These sumps come with a probe holder that can hold up to four probes. The holes are 0.63” in diameter.
